Hi all.
Forgive me i know very little about these machines but i am very mechanical and electronically minded so working on them shouldnt i hope be an issue!
Short story my partner bought a lightly used Iberital l'anna GR2 end of last year to use at home, they are coffee crazy and daughter is training to be be barista etc, anyhows its been working fine up until a few days ago and i came across this forum looking for some pointers but nothing same has shown up as yet, hopefully someone can point me in right direction and history of events and what ive tried below.
Im told it made some brews no problem earlier that day and was switched off,
They went back to it an hour or so later to power it up again and upon turning on only the red power light comes on and no matter what position switch is in there is no green boiler element light, also the switch panels on top are not illuminated either and no autofill.
I got there yesterday and checked water level it was midway between max and minimum but when drained would not autofill, was fine with manual fill button but still no panel lights or green boiler light
I removed panels to check fuse on main PCB which was ok and nothing obvious burnt out on PCB, also used multimeter to check element which i think i did right and was about 32ohm on each side of pair?
Manually turned the spindle on back of pump after reading on here they can seize and it seemed free to move.
Check boiler pressure cutout switch that seems ok
Checked over various connections and things unplugging and replugging etc but could see an nothing amiss all secure and contacts clean, it just doesnt seem to be powering up anything but the red power light, i carefully pushed the main contactor for element in and had power to the element so that seems ok.
Any tips or things to try next ?
Thanks in advance